Setting: Socket Controller
Here is a guide on how to use Socket Controller on Total Disturber app.
Details:
- Toggle socket ON or OFF
- Toggle all sockets to ON
- Toggle all sockets to OFF
- Connection status of the device
- List of available devices
- Button to refresh the device list
- Baud Rate of the device
- Total sockets available on the device
- Connect or disconnect device
- Test device
Important Notes:
- If you can't connect, don't forget to install your board driver.
- Please be careful when you work with high voltages.
- Avoid the potential for electrocution by paying attention to your electrical installation.
- Any loss that occurs while following this tutorial or using our application is the responsibility of the user.
USB Drivers:
- CP210x — https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers?tab=downloads
- CH340G — https://sparks.gogo.co.nz/ch340.html
- FTDI — https://support.arduino.cc/hc/en-us/articles/4411305694610-Install-or-update-FTDI-drivers
How to Make Socket Controller:
Tutorial:
Making Socket Controller (https://github.com/totaldisturber/socket-controller)
Buy from Vendors:
